S3L S3L2 S4L S4L2 Used Fuel Injection Pump For Excavator E308 Diesel
Specification
Car name: Fuel Injection Pump | Model Number: S4L | |
Quality: Standard | Engine type: Diesel | |
Application: Excavator | Part code: D94500-7400 | |
Cooling: Water cooling | Injection: Eddy |
Description
How to Replace a Fuel Pump in a Jeep Grand Cherokee
BY EDITORIAL TEAM
The Jeep Grand Cherokee has an electric fuel pump so you should ensure that its fuses and relays are working before checking it. You may need to clean your fuel pump or replace it if your gas tank is not empty, but your vehicle has difficulty getting fuel. The Jeep Grand Cherokee comes in a variety of styles and trim levels that can affect the replacement fuel pump you choose.
STEP 1
Determine which fuel pump your Jeep Grand Cherokee will need. This depends not only on the make and model, but also the engine size. Models made from 1999 to 2004 may be equipped with a 2.7 L OM647, 3.1 L 531, 4.0 L PowerTech, or 4.7 L PowerTech engine. Models made after 2004 can have a 3.0 L OM642, 3.7 L PowerTech, 4.7 L PowerTech, 5.7 L Hemi or 6.1 L Hemi.
STEP 2
Position your vehicle over a hoist and relieve the fuel system pressure. Raise your vehicle and drain the tank by loosening the clamp and removing the fill hose.
STEP 3
Unplug the fuel pump's electrical connection and disconnect the evaporative emissions lines and the fuel lines. Support the fuel tank with a hydraulic jack and remove the bolts on the fuel tank so you can lower the fuel tank.
STEP 4
Remove the lock ring on the fuel pump using tool 9340 with a ½ inch drive breaker bar to rotate the lock ring counter-clockwise. The fuel pump should rise up slightly when you remove the lock ring. Remove the fuel pump using care not to bend the float arm.
STEP 5
Install the new fuel pump using the items included in the kit, especially the rubber gasket for the fuel tank. Rotate the fuel pump until the alignment arrow points toward the alignment mark. Be sure the fitting on top of the fuel pump faces towards the driver's side. Tighten the lock ring with tool 9340 until all seven notches engage.
STEP 6
Complete the installation by reversing the removal procedure.